AUDIO / VIDEO / NAVIGATION EXHAUST BODY / FRAME LUGGAGE / SEATS COVERS / SECURITY WINDSHIELDS HANDLEBARS / CONTROLS LEVERS CABLES FOOTPEGS / FOOT CONTROLS INTAKE / FUEL SYSTEMS AIR FILTERS OIL FILTERS LIGHTING / GAUGES BATTERIES / CHARGERS ELECTRICAL SPARK PLUGS ENGINE CLUTCH / DRIVE SUSPENSION / BEARINGS CHAIN SPROCKETS BRAKES CHINESE VEHICLE PARTS STANDS TRANSPORT / RAMPS PROMOTIONAL INDEX x X X X X 530 • The Wig-Wag enables your brake lights to alternate back and forth in a wigwagging pattern. • This module is specifically designed for use with motorcycle’s that are equipped with 2 brake lights located side by side. • Choice of 2 different modes during installation. • 12 volts DC, Maximum Capacity 10 Amps! • Compact size. - 2-1/4”L x 1-5/8” W x 5/8”H sealed weather resistant heat sink case • Limited Warranty - One Year Description WPS# List Wig Wag Module 28-01009 $47.95 BACKOFF™ WIG WAG MODULE BACKOFF™ XP • This module converts your ordinary brake lights into your choice of two attention getting visual alerting signals when you apply your brakes: • Mode #1: Emits a visual signal of 4 short light flashes, followed by 1 long light flash (3.5 seconds). The signal automatically repeats itself as long as the brakes are applied. Mode #2: Emits a visual signal of 5 short flashes, followed by a steady on light that remains steady on as long as the brakes are applied • Compact - 2-1/4”L x 1-5/8”W x 5/8”H sealed weather resistant heat sink case • 12 volts DC, 10A max capacity • Limited Warranty - One Year NOTE: This module is rated at 10 Amps which will only drive 3 - 1156/1157 bulbs. Please DO NOT install any BackOFF Brake Light product on your turn signals, it is illegal and also confusing to following vehicles. Description WPS# List XP Module 28-01004 $47.95 Description WPS# List Turn Signal Module 28-01501 $79.95 SDC TURN SIGNAL CONVERSION MODULE • Allows your rear turn signal lights to function as turn signals plus additional brake and / or running lights • When brakes are applied your turn signals will illuminate as additional brake lights • If a turn signal is applied, it will have priority over the brake light function on the side that is selected until the turn signal is canceled • Additionally, the rear light can function as running / marker lights when there is no turn signal or brake light (illuminates at 50% brightness) Note: If you convert turn signals into brake lights, you will need to change the bulb / lens to red: or replace the turn signal light with a red light Description WPS# List Dual-Load Equalizer 28-01008 $21.95 DUAL-LOAD EQUALIZER • The Dual Load Equalizer is designed to correct the issue of turn signals flashing too quickly or not at all. It does this by adding back the load to your mechanical flasher relay that was removed by converting stock incandescent turn signals to LED’s • Dependable weather proof Solid-state electronic components • Dimensions: 2 1/4” L x 1 5/8” W x 5/8” H • One equalizer per set of lights LIGHTING / GAUGES
RkJQdWJsaXNoZXIy OTUwNDk=