x X X X X 268 RUNNERS TOP-STOCK™ Top-Stock™ is an economical hard weld runner designed for extreme service or utility applications. The 1/2” host bar with hard weld increases the depth of the runner for added controllability. Recommended for deep snow or snowmobiles with 48 or fewer studs installed. 8" EXECUTIVE™ This single runner provides balanced traction for performance-based trail and cross country riders with studded tracks. Its 8 inches of 60° turning carbide is strategically placed under the ½” host bar to provide superior traction and protect the steel bar from excessive wear. SLIM JIM® DOOLY™ For riders who like the reduced darting feature of the original Dooly, but also want a lighter, performance-based runner for responsive cornering. Formed from one piece of steel, this dual runner comes with 4, 6, and 8 inches of 60° carbide on two narrow blades, providing extreme control. Sold individually. DOOLY™ Each of these dual carbide runners have two single runners mounted to a steel plate, producing a total of four contact lines on the terrain. These four blades with 60° carbide drastically reduce darting as they carve through existing grooves from single runners. This design spreads the PSI across two points, which extends the life of the runner and eases steering. When turning, only one blade per dual runner will contact the terrain, acting like a pair of single runners. Available with 4", 6", and 8" carbide per blade; exceptions exist for runners with short lengths. Sold individually. ACE™ This carbide runner is the tallest in the industry and has a narrow, rectangular profile for aggressive turning capabilities. Its 60° turning carbide, available in 4", 6", and 8", has been strategically placed to protect the runner and reduce darting by carving through existing grooves. Works great on Crossovers and in deep snow! 4" EXTENDER TRAIL III™ Woody's entry level carbide runner featuring four inches of 60° carbide and a 7/16" host bar. Whether you're looking for a replacement factory runner, a cutting edge in hard-packed snow and ice, or to improve your safety & handling, this option is for you. For use on snowmobiles with un-studded to lightly studded tracks. 6" TRAIL BLAZER IV™ This runner has six inches of 60° turning carbide beneath its ½” host bar – a great choice if you are looking for overall improvement in safety and handling, or to replace your factory runner. Use with a studded or un-studded track. SLIM JIM® 2.0 DOOLY™ Sold Individually/ One per ski Much like the original Slim Jim, the Slim Jim 2.0 is a performance based runner for responsive cornering. Formed using one piece of steel, this dual runner comes with 4, 6, and 8 inches of carbide on two narrow blades, providing exceptional control. the 2.0 model is lighter and stronger than the original. Sold individually. SNOW BIKE SURVIVAL SNOWMOBILE ACCESSORIES HANDLEBARS / CONTROLS CABLES WINDSHIELDS BODY TUNNEL SKIS /RUNNERS FRONT SUSPENSION REAR SUSPENSION SHOCKS TRACKS/STUDS SPROCKETS ELECTRICAL EXHAUST ENGINE AIR / FUEL CLUTCHING BELTS BRAKES CHAIN / SPROCKETS LUBRICANTS / CHEMICALS TOOLS / HARDWARE TRANSPORT / RAMPS PROMOTIONAL INDEX SKIS / RUNNERS
RkJQdWJsaXNoZXIy OTUwNDk=