AUDIO / VIDEO / NAVIGATION EXHAUST BODY / FRAME LUGGAGE / SEATS COVERS / SECURITY WINDSHIELDS HANDLEBARS / CONTROLS LEVERS CABLES FOOTPEGS / FOOT CONTROLS INTAKE / FUEL SYSTEMS AIR FILTERS OIL FILTERS LIGHTING / GAUGES BATTERIES / CHARGERS ELECTRICAL SPARK PLUGS ENGINE CLUTCH / DRIVE SUSPENSION / BEARINGS CHAIN SPROCKETS BRAKES CHINESE VEHICLE PARTS STANDS TRANSPORT / RAMPS PROMOTIONAL REFERENCE INDEX x X X X X 600 • The Wig-Wag enables your brake lights to alternate back and forth in a wigwagging pattern. • This module is specifically designed for use with motorcycle’s that are equipped with 2 brake lights located side by side. • Choice of 2 different modes during installation. • 12 volts DC, Maximum Capacity 10 Amps! • Compact size. - 2-1/4”L x 1-5/8” W x 5/8”H sealed weather resistant heat sink case • Limited Warranty - One Year • Compact solid state module converts your ordinary brake light into an attention getting visual alerting device, more visibility and conspicuity when you are stopped or stopping • With BackOFF installed, when you apply your brakes, it causes your brake light to automatically emit a visual alerting signal of 3 short light flashes, followed by 1 steady on light condition of 3.5 seconds • Signal automatically repeats itself as long as the brakes are applied • Compact size. - 2-1/4”L x 1-5/8” W x 5/8”H • 12 volts DC, 10A max THE ORIGINAL BACKOFF™ BRAKE LIGHT MODULE WPS# List 28-01001 $41.95 BACKOFF™ BRAKE HOLD MODULE • The Brake Hold Module connects to your bike’s electronic speed pick-up sensor (will not work with cable driven speedometers); to keep your brake lights on when you release your brakes but are still decelerating • Mode #1: Emits a visual signal of 3 short light flashes, followed by 1 long light flash (3.5 seconds). The signal automatically repeats itself as long as the brake lights are on. Mode #2: Emits a visual signal of 5 quick flashes, followed by a steady on light that remains steady as long as the brake lights are on • 12 volts DC - Maximum Capacity: 10 Amps (normally up to 3 bulbs)! • Compact size. - 2-1/4”L x 1-5/8” W x 5/8”H sealed weather resistant heat sink case. • 1 Year limited warranty • Your Bike MUST have Electronic Pick-Up Sensor for this module to function WPS# List 28-01020 $69.95 WPS# List 28-01009 $47.95 BACKOFF™ WIG WAG MODULE BACKOFF™ XP • This module converts your ordinary brake lights into your choice of two attention getting visual alerting signals when you apply your brakes: • Mode #1: Emits a visual signal of 4 short light flashes, followed by 1 long light flash (3.5 seconds). The signal automatically repeats itself as long as the brakes are applied. Mode #2: Emits a visual signal of 5 short flashes, followed by a steady on light that remains steady on as long as the brakes are applied • Compact - 2-1/4”L x 1-5/8”W x 5/8”H sealed weather resistant heat sink case • 12 volts DC, 10A max capacity • Limited Warranty - One Year WPS# List 28-01004 $47.95 NOTE: This module is rated at 10 Amps which will only drive 3 - 1156/1157 bulbs. Please DO NOT install any BackOFF Brake Light product on your turn signals, it is illegal and also confusing to following vehicles. LIGHTING / GAUGES
RkJQdWJsaXNoZXIy OTUwNDk=