2022 Snow

x X X X X 1266 WPS# List 18-3985 $59.98 TRACK MARKER • For use with Woody’s studding templates • Leaves a white mark to indicate stud placement • Check your completed pattern before drilling holes TRACK TENSION TOOL Description WPS# List For 5/16” I.D. plates 18-3986 $21.98 INDEXING TOOL FOR SQUARE SUPPORT PLATES Parallel edges are essential. Square support plates should run parallel with the edges of the track to increase the longevity of the stud and support plate. The indexing tool quickly aligns support plates with track edges. Fits 3/8”‘ drive ratchet. WPS# List 18-3980 $9.49 STUD INSTALLATION TOOL A great new tool for installing studs made for all Woody’s studs. The aluminum handle rests in the palm of your hand so you can apply pressure needed to keep the stud from rotating as you torque the nut. Each tool comes with two hex bits. UNIVERSAL TRACK DRILL • Essential for snowmobile track studding • Hollow tool drills a clean hole through rubber tracks for all stud sizes WPS# List 18-3982 $33.98 WPS# List 18-3983 $13.98 It is highly recommended that when traction studs are installed, templates be used for proper placement on the track. Please refer to PAGES 5579-580 for stud templates. We have all the necessary templates needed for the different machines and track styles STUDDING TEMPLATES TRACK CLIP TOOL • Manufactured by KB Tooling exclusively for Woody’s • Can be used while track is still on sled • Top is made of case hardened 1018 steel • Anvil is made of 6061 T6 tempered aluminum with a hardened steel ball locked in for the bolt to press on • Anvil locked in by 2 hardened shoulder bolts; worry free from falling out or being crooked • Drive bolt is grade 8 and designed to fit perfectly on the anvil ball • Base plate is fitted with rubber grips and is cut with clearance for guided track clips • Accessory part needed for tracks with lugs heights between 2” and 3” Description WPS# List Track Clip Tool 11-2400 $105.98 2-3” Lug Accessory 11-2401 $55.98 WPS# List 18-3981 $124.98 STUD SHARPENING TOOL Description WPS# List 1/4” x 20 Thread 18-1080 $23.98 T-NUT PULLER • Reduces time required to stud track • Fits 3/8" square drives/drills and is available for 1/4"-20 t-nuts • Optimize performance and prolong the life of your track with regular use of this handy tool • Set the weight and measure the tension of your track • Follow recommendation in your snowmobile owner's manual • Steel stud sharpener (not intended for carbide use) • Fits 3/8" drill • Sharpens in 30° angle SNOW BIKE SURVIVAL SNOWMOBILE ACCESSORIES HANDLEBARS / CONTROLS CABLES WINDSHIELDS BODY TUNNEL SKIS / RUNNERS FRONT SUSPENSION REAR SUSPENSION SHOCKS TRACKS/STUDS SPROCKETS ELECTRICAL EXHAUST ENGINE AIR / FUEL CLUTCHING BELTS BRAKES CHAIN / SPROCKETS LUBRICANTS / CHEMICALS TOOLS / HARDWARE TRANSPORT / RAMPS PROMOTIONAL INDEX TOOLS / HARDWARE

RkJQdWJsaXNoZXIy OTUwNDk=